Aerial view of a large industrial roof with rooftop units and drains
SystemsTPO · EPDM · Metal
Commercial Roofing · Paducah, KY

Paducah Commercial Roofing Contractor

Roof Systems for Warehouses, Plants, Shops and Office Buildings

As a Paducah commercial roofing contractor, we install, replace and repair TPO, EPDM, flat and metal roofs on commercial, industrial and farm buildings.

Get A Free EstimateCall Us
CoveragePaducah + 15 Towns
  • Inspection first on every roof
  • TPO, EPDM, metal and flat roofs
  • Commercial and industrial buildings only
  • McCracken County and nearby towns

Roof Services From Your Paducah Commercial Roofing Contractor

Here is the work we take on as a Paducah commercial roofing contractor, from a single leaking seam to a full tear-off and a new membrane.

Roofer walking a commercial roof to check seams, drains and flashing
Leaks and Damage

Commercial Roof Repair

Water at a ceiling tile usually traces back to an open seam, a cracked pipe boot or a loose panel lap. We find the entry point on the roof and repair it with matching material.

  • Seams, laps and flashing resealed or rewelded
  • Backed-out screws swapped for larger fasteners
  • Storm and hail damage checked section by section
Paducah commercial roof repair
Roofers heat-welding white TPO membrane seams on a low-slope commercial roof
Single-Ply Membrane

TPO Roofing

TPO is the white heat-welded membrane on many low-slope warehouses and retail buildings. Each lap is fused with a hot-air welder and probed afterward, and the white surface reflects summer sun.

  • 45, 60 or 80 mil sheets
  • Mechanically attached or fully adhered
  • Walkway pads along rooftop unit service paths
TPO roofing in Paducah
Crew rolling out black EPDM rubber membrane on a commercial roof
Rubber Membrane

EPDM Roofing

Black or white EPDM rubber stays flexible through hot July afternoons and freezing January nights. Wide sheets mean fewer seams, and each lap is primed and joined with seam tape.

  • Fully adhered, fastened or ballasted sheets
  • Molded pipe boots and clamped drain rings
  • Recover over dry insulation after a moisture survey
EPDM roofing in Paducah
Crew tearing off an old commercial roof down to the deck
Low-Slope Roofs

Flat Roofing

Ponding rings around drains tell you a flat roof needs more slope. Tapered insulation, crickets behind curbs and new drain bowls move water off before it sits and wears the membrane.

  • Tear-off down to the deck where boards are wet
  • Tapered polyiso sloped toward each drain
  • Overflow scuppers set above the primary drains
Flat roofing in Paducah
Roofing crew truck staged beside a commercial building with materials
Plants and Distribution

Industrial Roofing

Plant roofs carry exhaust fans, process stacks and pipe racks, so the membrane is chosen against what settles on it. Curbs get raised and reflashed one section at a time while production keeps running.

  • Membranes checked against chemical resistance charts
  • High-density cover board under heavy traffic
  • Crane and material staging away from entrances
Industrial roofing in Paducah
Roofers fastening metal roof panels on a commercial building
Standing Seam and R-Panel

Commercial Metal Roofing

Shops, barns and pre-engineered steel buildings wear standing seam or exposed-fastener R-panel roofs. We install new panels, repair leaking laps and fasteners, and handle seasonal upkeep.

  • 24 or 26 gauge panels with matching trim
  • Retrofit framing to put metal over a flat roof
  • Spring and fall fastener and sealant checks
Commercial metal roofing in Paducah

Benefits of a New Commercial Roof

A rebuilt roof pays off in three places: up on the roof, inside the building, and in how you plan repairs and spending.

On The Roof

Tight Seams and Laps

Welded TPO laps, taped EPDM seams and resealed metal end laps close the spots where most leaks start on an older roof.

Water Moving to Drains

Tapered insulation and crickets slope the surface toward drains and scuppers, so storm water leaves the roof instead of sitting in rings around curbs.

Inside The Building

Dry Ceilings and Stock

Replacing wet insulation and resealing curb flashing stops the drips that stain ceiling tile and soak pallets, files or equipment below.

Steadier Indoor Temperatures

New polyiso boards laid in staggered layers slow heat flow through the roof, which helps air-conditioned offices and shops hold temperature in July.

For Planning And Budget

Fewer Repeat Service Calls

Rebuilding the edges, curbs and drains along with the membrane ends the cycle of patching one leak while another opens a few feet away.

Records for Taxes and Insurance

Invoices and a written scope from tear-off to edge metal give your CPA and insurance adjuster what they need to review a capital roof project.

Roof Problems We Find on Paducah Buildings

Most leak calls come back to a short list of conditions. Here is the one we see most, plus four more worth checking after a storm.

Most Common

Open Seams and Laps

Seams take the most movement on a commercial roof. Old EPDM laps glued with liquid adhesive let go first, TPO welds can split at inside corners, and metal end laps loosen as panels expand and contract between summer heat and freezing nights.

Usually Means: Repair the lap now; widespread seam failure points to replacement.

Ponding After Storms

Water standing two days after rain marks a low spot, a clogged drain or crushed insulation under the membrane.

Backed-Out Screws

Exposed-fastener metal roofs lose washers and screws to heat cycling, and each open hole lets water reach the purlins.

Leaks at Rooftop Units

Curb flashing that was never raised for added insulation lets wind-driven rain run under the membrane at HVAC units.

Loose Edge Metal

High winds peel a roof from its corners first, starting where edge metal or coping caps have worked loose.

Water Coming Through a Ceiling Tile Right Now?

Call us and describe where the water shows up inside. We will talk through the likely source on the roof and set up an inspection.

(618) 386-4443Call Us

How a Commercial Roofing Job Runs in Paducah

Every project starts with a roof walk and core cuts, then moves through the permit, tear-off and the new system in watertight sections.

Inspect First

  1. Inspect Your Roof

    DAY 1

    We walk the field, cut small cores to see each layer, take moisture readings and check the deck from inside the building. Photos of every finding go into a written summary.

  2. Choose the System

    PLAN

    Roof pitch, building use and the deck decide between TPO, EPDM or metal. Wet insulation found in the survey settles whether the old roof comes off or a recover makes sense.

  3. Pull the Permit

    PERMIT

    Inside city limits, Paducah's Building Division handles construction permits, and McCracken County's Inspection Department covers sites outside the city. Drawings show the roof assembly, insulation and edge details.

  4. Build It in Sections

    ROOF

    Crews open only the area they can dry in by evening, then lay insulation, cover board and membrane or panels, and tie each section off watertight before leaving.

  5. Finish the Edges

    CLOSE-OUT

    Edge metal, coping caps, curb flashing and drain clamping rings go on last, and every welded or taped seam is probed before the final walk with you.

Schedule Your Free Inspection

Repair, Recover or Replace Your Roof?

Match what you see on your roof to the closest card below. The inspection confirms which one applies.

If Your Roof

Leaks at One Seam or Curb

The rest of the membrane feels firm and dry underfoot.

Start WithCommercial Roof Repair
If Your Roof

Dry Insulation Under a Worn Membrane

Core cuts show dry boards, and the roof has only one existing layer.

Start WithA Recover Over the Old Roof
If Your Roof

Soft Spots and Wet Boards Across the Field

Moisture readings mark wet insulation over much of the roof.

Start WithFull Tear-Off and Replacement
Get An Estimate

Serving Paducah and Fifteen Nearby Towns

Is your building near Paducah? We install and repair commercial roofs in every town listed below. For anywhere else, call us or send us a message.

Home Base · McCracken County

Paducah

Riverfront masonry, warehouses and plants, with permits through the city or county office.

B

Benton

Marshall County seat; permits through the county Building Office.

C

Calvert City

Plant and warehouse roofs along the Tennessee River.

E

Eddyville

Lyon County seat with lake wind at the eaves.

F
FredoniaCaldwell County
G
GilbertsvilleMarshall County
Grand RiversLivingston County
H
HardinMarshall County
K
KevilBallard County
KuttawaLyon County
L
La CenterBallard County
M

Mayfield

Graves County roofs rebuilt with storm-rated edge metal.

Murray

Offices and shops reviewed by the City of Murray.

R
ReidlandMcCracken County
S
SmithlandLivingston County
W
WickliffeBallard County

Top Commercial Roofing Questions From Paducah Owners

Short answers sit on each row. Open one for the details on roof types, weather, cost and permits.

What kinds of roofs go on commercial buildings in Paducah?

Membrane or metal

Two families cover most of them. Low-slope warehouses, strip centers and plants carry TPO or EPDM membranes that drain to interior drains or scuppers. Shops, barns and pre-engineered steel buildings with visible pitch carry standing seam or R-panel metal. Pitch, the deck and how the building is used decide which family fits.

How does Paducah weather affect a new commercial roof?

Edges and seams first

Hot, humid summers, freezing nights and strong spring and fall storms all work on the perimeter first. Wind pulls at loose edge metal, hail bruises insulation that has no cover board, and cold limits when adhesives and seam tape can go down. Edge fastening, cover board and work days get planned around those conditions.

What drives the cost of a new commercial roof?

Size, system, tear-off

Square footage, the system chosen and how many old layers come off set most of the cost of a new commercial roof in Paducah. Each curb, pipe, drain and skylight adds flashing work, and so do long runs of edge metal. Crane access and deck damage found during tear-off round it out, so a roof walk comes first.

Does a commercial roof replacement in Paducah need a permit?

Ask the city first

Paducah's Building Division requires a construction permit for new construction, additions and renovations, and it confirms how a given replacement fits that rule. Buildings outside city limits go through McCracken County's Inspection Department. Have the roof area, the new system, tear-off or recover, and any curb, skylight or drain changes ready for that first call.

What happens during a roof assessment before a new commercial roof?

Cores, readings, photos

Someone walks the whole field, cuts small cores to see each layer, and takes moisture readings to mark wet insulation. The deck gets checked from inside for rust or sag, and edges, drains and curbs are measured. You get photos of each finding, a clear call on tear-off or recover, and the system that fits the building.

Hire a Paducah Commercial Roofing Contractor

Tell us about the building and what you see on the roof. We will set up a roof walk and a free estimate for the work it needs.

Get A Free EstimateCall Us
Call Us (618) 386-4443